skip to main content

Comparison Between Conventional Design and Cathode Gas Recirculation Design of a Direct-Syngas Solid Oxide Fuel Cell–Gas Turbine Hybrid Systems Part I: Design Performance

Department of Mechanical Engineering, Mohaghegh Ardabili University, Iran, Islamic Republic of

Published: 25 Jun 2017.
Editor(s): H Hadiyanto

Citation Format:
Abstract

In this paper, a conventional SOFC–GT hybrid system and a SOFC–GT hybrid system with cathode gas recirculation system fueled with syngas as the main source of energy were analyzed and their performances were compared. In the conventional SOFC–GT hybrid system, the incoming air to the cathode was heated at air recuperator and air preheater to meet the required cathode inlet temperature. In the SOFC–GT hybrid system with cathode gas recirculation, besides air recuperator and air preheater, the recirculation of the cathode exhaust gas was also used to meet the required cathode inlet temperature. The system performances have been analyzed by means of models developed with the computer program Cycle–Tempo. A complete model of the SOFC–GT hybrid system with these two configurations evaluated in terms of energy and exergy efficiencies and their performance characteristics were compared. Simulation results show that the electrical energy and exergy efficiencies achieved in the cathode gas recirculation plant (64.76% and 66.28%, respectively) are significantly higher than those obtained in the conventional plant (54.53% and 55.8%). 

Article History: Received Feb 23rd 2017; Received in revised form May 26th 2017; Accepted June 1st 2017; Available online

How to Cite This Article: Azami, V, and Yari, M. (2017) Comparison between conventional design and cathode gas recirculation design of a direct-syngas solid oxide fuel cell–gas turbine hybrid systems part I: Design performance. International Journal of Renewable Energy Development, 6(2), 127-136.

https://doi.org/10.14710/ijred.6.2.127-136

Fulltext View|Download

Article Metrics:

  1. Ankur scientific energy technologies pvt. ltd, http://www.ankurscientific.com/range.htm; 2010
  2. Aravind, P.V., Woudstra, T., Woudstra, N. & Spliethoff, H. (2009) Thermodynamic evaluation of small scale systems with biomass gasifiers, solid oxide fuel cells with Ni/GDC anodes and gas turbines. J Power Sources, 190(2), 461–75
  3. Delft University of Technology. (2017) Cycle-tempo software (Release 5.0), http://www.asimptote.nl/software/cycle-tempo
  4. Delft University of Technology. (2017) Cycle-tempo manuals http://www.asimptote.nl/assets/media/7d155f62-ffe2-4a9e-9f33-bb003c80bd2b.pdf
  5. Hirschenhofer, J.H., Stauler, D.B., Engleman, R.R. & Klett, M.G. (1998) Fuel cell handbook. 4th ed. Parsons Corporation Reading P.A. for U.S. Department of Energy
  6. Kuchonthara, P., Bhattacharya, S. & Tsutsumi, A. (2003) Combinations of solid oxide fuel cell and several enhanced gas turbine cycles. Journal of Power Sources, 124, 65–75
  7. McLarty, D., Kuniba, Y., Brouwer, J., Samuelsen, S. (2012) Experimental and theoretical evidence for control requirements in solid oxide fuel cell gas turbine hybrid systems. J Power Sources, 209, 195–203
  8. Park, S.K. & Kim, T.S. (2006) Comparison between pressurized design and ambient pressure design of hybrid solid oxide fuel cell gas-turbine systems. J Power Sources, 158, 225–44
  9. Park, S.K., Kim, T.S., Sohn, J.L. & Mech, J. (2009) Influence of steam injection through exhaust heat recovery on the design performance of solid oxide fuel cell — gas turbine hybrid systems. J Mech Sci Technol 23:550–8
  10. Saebea, D., Patcharavochot, Y. & Arpornwichanop, A. (2012) Analysis of an ethanolfuelled solid oxide fuel cell system using partial anode exhaust gas recirculation. J Power Sources, 208: 120–30
  11. Rokni, M. (2010) Plant characteristics of an integrated solid oxide fuel cell cycle and a steam cycle. Energy 2010;35:4691–9
  12. Rokni, M. (2010) Thermodynamic analysis of an integrated solid oxide fuel cell cycle with a rankine cycle. Energy Conversion and Management, 51:2724–32
  13. Toonssen, R., Aravind, P.V., Smit, G., Woudstra, N. & Verkooijen, A.H.M. (2010) System study on hydrothermal gasification combined with a hybrid solid oxide fuel cell gas turbine. Fuel Cells, doi: 10.1002/fuce.2009001
  14. Website:
  15. https://www.siemens.com/global/en/home.html

Last update:

  1. A Regenerative Coking and Sulfur Resistant Composite Anode with Cu Exsolution for Intermediate Temperature Solid Oxide Fuel Cells

    Ning Zhou, Yi-Mei Yin, Zonghai Chen, Yefeng Song, Jiewei Yin, Ding Zhou, Zi-Feng Ma. Journal of The Electrochemical Society, 165 (9), 2018. doi: 10.1149/2.0841809jes
  2. Cycle-Tempo Simulation of Ultra-Micro Gas Turbine Fueled by Producer Gas Resulting from Leaf Waste Gasification

    Fajri Vidian, Putra Anugrah Peranginangin, Muhamad Yulianto. Journal of Mechanical Engineering, 24 (3), 2021. doi: 10.15407/pmach2021.03.014

Last update: 2024-10-05 03:49:17

No citation recorded.